Follow these steps at each cable entry point and termination location to achieve a compliant, safe ground bond: Identify metallic components. Strip back approximately 6–8 inches of the outer jacket using a cable slitter or ringing tool. Visually identify armor, strength members, or foil layers. This Applications Engineering Note (AE Note) discusses conventional bonding and grounding practices for conductive fiber optic cable and hardware installations within the scope of the National Electrical Code (NEC). Project success depends on careful planning, precise installation practices, and proper. In installations where an optical fiber cable is exposed to contact with electric light or power conductors and the cable enters the building, the non–current-carrying metallic members shall be either grounded as specified in 770. 100, or interrupted by an insulating joint or equivalent device. The. Minimize mechanical pressure on the outer sheath at crossing points: (armoured) cables crossing each other generate points of high pressure, so it is important when laying in figure 8 loops it is done in a correct way. When laying loops of fiber on a surface during a pull, use “figure-8” loops to. For longer distances, fiber-optic cables are typically installed by hanging them between poles (aerial), laying them on the seabed (submarine), or burying them in the ground (underground). The specific environmental conditions of a project determine which method – or combination of methods – is the.
